Higo Splice Cable to CA3 for 72V PAS

The linear regulator on the Cycle Analyst limits how much current can be supplied on the 12V bus that powers PAS and torque sensors, especially at higher voltages. In practice, this means 60V or 72V setups cannot connect a torque sensor directly to the CA3 without overheating it. This cable solves the problem by tapping into the 12V bus already present on the Phaserunner's 6-pin Higo plug.

The 6-pin M-F Higo extension cable plugs in between the controller and the torque sensor to supply 12V power, while a spliced wire carries the PAS and torque signals up to the Cycle Analyst through the 5-pin JST plug.