Thanks for your patience everyone during this website migration. Order checkout is now fully enabled!

There are clearly many visual glitches with the layout and the image and video embedding that we are working to iron out. 


WP8_F

Short WP8 Female Cable with Pigtail Leads for Modifying Controllers for New CA3-WP Compatibility
USD$7.00
Availability: In stock
SKU
W-WP8_F

24cm cable with WP8 connector that can be used for upgrading motor controllers to use the new 8 pin CA plug standard. See this guide for complete details. Six of the colours (red, black, blue, white, green, and yellow) connect exactly the same way as the 6-pin JST plug, while the extra orange wire is for the on/off key switch return, and the extra grey wire is a pass-thru for the motor temperature sensor.

  • Red: Connection to positive battery bus.
  • Orange: Key Return. When the handlebar On/Off switch is on, then this is connected to V+ from the red wire. Normally this pad is labelled K or K+ on the motor controller PCB. On a Grinfineon controller, it would be the same as one of the wires from the on/off switch.  
  • Black: Connection to Ground reference, negative battery bus.
  • Blue: Negative (battery) side of the controller's shunt resistor
  • White: Positive (mosfet) side of the controller's shunt resistor
  • Yellow: Pass-thru for vehicle speed sensor, either a hall pin (for direct drive motors) or an internal speedo (for geared motors)
  • Green: Throttle input signal
  • Grey: Pass through of motor temperature signal
More Information
Actual Weight (kg) 0.03
We found other products you might like!