FH212 Standard Wind

Nine Continent Front Hub Motor, FH212 Model with Proper Bike Alignment, Statorade Ready, and L10 Connector. Fast 8.5 RPM/V Winding

From USD$240.00

To USD$555.60

In stock

SKU
BUNDLE-FH212_Std
Customize FH212 Standard Wind
FH212_Std

Nine Continent Front Hub Motor, FH212 Model with Proper Bike Alignment, Statorade Ready, and L10 Connector. Standard 8.5 RPM/V Winding

Click Here for detailed product info page

Nine Continent Front Hub Motor, FH212 Model with Proper Bike Alignment, Statorade Ready, and L10 Connector. Standard 8.5 RPM/V Winding

Click Here for detailed product info page

GRIN Front Torque Arm for Mounting on Forks with Fender Eyelets. Thick 1/4" Stainless Plate. Also Available on Amazon for US customers Full Product Information Page

Click Here for detailed product info page

GRIN Front Torque Arm for Mounting on Forks with Fender Eyelets. Thick 1/4" Stainless Plate. Also Available on Amazon for US customers Full Product Information Page

Click Here for detailed product info page

Laser Engrave 250 Watt Continuous Power Rating on Motor Side Plate. This is Truthful. ALL Hub Motors Offered by Grin Have an Operating Point (RPM and Allowable Temperature) Where They Can Only Sustain 250W. 

Click Here for detailed product info page

* Required Fields

Your Customization
Ready to Roll Kit with FH212 Direct Drive Front Hub Motor (ignore fact that rear motor shown in pic)
FH212 Standard Wind

In stock

USD$260.00

Unable to add to cart because these items are out of stock:

Summary
  • FH212_Std:
    1 x FH212_Std
    SKU#: M-MFH212_Std
  • Front Torque Arm:
    1 x V2 Front Torque Arm
    SKU#: TA-TorqArm_V2

Nine Continent Front Hub Motor with larger 212mm rotor diameter for higher torque and better copper fill than normal 205mm DD hub motors. 27mm wide stator with 0.35mm laminations for reduced rolling drag and side cable exit for better protection and torque arm installation.

Has 100mm front axle length and proper disk rotor alignment and caliper clearance for standard bike fit compatibility.

Terminated with new L10 waterproof high power motor connector and includes 10K NTC thermistor for motor temperature sensing and thermal rollback, plus sealed side plates with Statorade injection port via disk rotor hole.