Canadian
Baserunner_L10 Controller
V6 Baserunner_L10 Field Oriented Motor Controller. Flat Profile Fits Many Downtube Battery Enclosures. L1019 Motor Plug. 80A Peak Phase Currents (~45-50A Continuous), for 24-52V Batteries (60V Max Input).
From USD$250.00
To USD$307.00
In stock
The Baserunner_L10 is a compact field-oriented motor controller and enclosure that fits inside the Hailong and Reention downtube battery cradles. It is compatible with up to 14s (58V) battery packs, supports up to 80A peak phase current through the L1019 waterproof motor plug.
- 8-pin HiGo plug for CA3-WP control (To convert the WP8 to a classic CA-DP, you must purchase an adapter.)
- 9-pin Cusmade Mains signal plug for harnesses to 3rd party displays, alternately use to power rear light
- 6-pin HiGo MiniB for direct PAS or Torque Sensor when using 3rd party displays
The baserunner purchased on its own has short bare + and - lead wires.
If it is purchased along with a regular battery from us we will crimp on anderson powerpoles.
If it is purchased with the Reention battery cradle, then we will solder the leads to the 4 pin spade plugs of the cradle.
A computer setup is required to configure this controller to a given motor, and this requires the USB->TTL communications cable if you don't already have one. Users without an on-off switch on their battery should expect to wire in a separate switch on their own. Full Baserunner Information Page.
