ERider100-T17 BB with 52T Chainring

Complete Torque Sensor Crankset: ERider-T17N for 100mm BB Shells with Side Cable Exit, 170mm Miranda Cranks and 4 Bolt 104mm BCD Spider with a 52T Chainring. 

USD$219.00
Availability: In stock
SKU
BB-ERider100Q_52T

ERider torque sensor and crankset for 100mm wide bottom bracket shells (fatbikes) with a 4 bolt 104mm spider and a 52T narrow-wide chainring compatible with most mountain/fatbikes. Unlike most other bottom bracket torque sensors, the ERider-T17N model has a cable exit from the side of the cartridge and does not require drilling a hole through the frame. This torque sensor accurately measures both left and right pedal torques and enables a very responsive PAS system. The 2 wire quadrature signal for the cadence sensing allows it to take advantage of the latest CA3 firmware which tracks back-pedal sensing for regenerative braking where applicable.

Includes 0 Q factor 165mm Miranda Cranks.

This sensor has an 18 pole 2 wire cadence sensor and a 1.5V - 3.5V output voltage that is proportional to crank torque with a scaling of 70 Nm/V. Includes 90cm long cable terminated with JST-SM connector, plug-and-play with V3 Cycle Analyst

NOTE: Certain ERider setups are succeptible to electrical noise from the controller causing intermittent cutout behavior. This can be solved by grounding the bicycle frame. 

More Information
Actual Weight (kg) 1.3
Connector(s) Higo Signal C, JST-SM
PAS Poles 18
PAS Encoder Type 2 Wire (Quadrature)
Sensor Supply Voltage 5-15V
Torque Scale 70 Nm/V
Torque Sensor Offset Voltage 1.5V