36-52V, 20A Sinewave Controller with ON/OFF Switch and Either 90cm or 120cm (for Front hub) Motor Phase Cable using Waterproof Z910 Higo Connector. For use with GEARED hub motors with standard Bafang pinout - not compatible with motors with combined speed and temp signal without modification. New Model with WP8 CA Plug.
20A Sinweave Grinfineon Controller
- New WP8 Cycle Analyst Connector
- Wide Input Voltage Range (27-58V)
- Includes Waterproof 9 Pin Higo Z910 Connector for Motor Phase, Hall, and Speed
- Operates both Sensored and Sensorless
- Quiet Sinusdoial Output when Sensored
- Sensorless up to 28000 eRPM, Geared Motor Compatible
- Fully Proportional Regenerative Braking from 0-0.8V Throttle Signal
- FWD/REV Input Wire
- Integrated ON/OFF Push Button Switch with Rubber Boot
- Waterproof Gasket
Compatible with motors that use standard Bafang Hall pinout.
For more information please see the Grinfineon controller page.
|Country of Manufacture||China|
|Dimensions (L x W x H, mm)||110 x 71 x 34|
|Actual Weight (kg)||0.4700|
|Max Regen Voltage (V)||58|
|Max Battery Amps (A)||20|
|Battery Range (V)||36V-52V Nominal|
|Low Voltage Cutoff (V)||27|
|MOSFETs||6 x AOT460|
|Control Chip||XCKJ 3232C|
|Connector(s)||Anderson, JST-SM, WP8 (HiGo 0812), Z910|