Frankenrunner_L10 Controller

Frankenrunner Controller with Over-molded L1019 Motor Connector and WP8 CA Plug. 87V Max Battery Voltage and 96A Peak Phase Currents. Includes XT60 to Anderson Battery Cable.

Full Info Page

From USD$325.00

To USD$379.00

In stock

Customize Frankenrunner_L10 Controller

* Required Fields

Your Customization
Phasernuner_MT V3 Side View
Frankenrunner_L10 Controller

In stock



    Frankenrunner with over-molded locking 10-pin L10 connector. Comes with a 40cm motor cable.

    • 8-pin HiGo plug for CA3-WP control (To convert the WP8 to a classic CA-DP, you must purchase an adapter.)
    • 9-pin Cusmade Mains signal plug for harness to headless system or 3rd party displays
    • 6-pin HiGo MiniB Male - For direct PAS and Torque Sensor hookeup with 3rd party displays (only supported for OEM customers)
    • Includes a 30cm XT60 to Anderson battery cable.

    Must be setup with via a computer to mate and configure with a given motor if they are not purchased together, and this requires the USB->TTL communications cable if you don't already have that.

    If you are NOT running the device with a V3 Cycle Analyst, then please also get one of the 9 pin mains cable harnesses to more conveniently access throttle, ebrake, and other signals.

    Full Frankenrunner Information Page.

    Frankenrunner L10
    Dimensions (L x W x H, mm)
    Actual Weight (kg)
    Max Regen Voltage (V)
    Max Battery Amps (A)
    Max Phase Amps (A)
    Battery Range (V)
    7s - 20s (24 - 72V nominal)
    Anderson, HiGo 0812(WP8), L1019, TRRS, XT60, HiGo MiniB, HiGo D 1109
    More Information