Canadian
PAS Grounding Cable
Grounding Cable for 6-pin Higo PAS Plug on Grin Controllers. Connects Bicycle Frame to Battery Ground to Resolve Occasional ERider Torque Sensor Freezing Issues. For Use with Cycle Analyst Systems, not Superharness Systems.
For some reason certain torque sensors (ERider and Sempu) are susceptible to electrical interference with ASI based motor controllers, resulting in the torque output signal occasionally getting stuck high or low. That in turn causes excessive power when pedaling or none at all, usually until the power is turned off and on and the torque sensor electronics reset. This happens in just a minority of installations and experience has shown that it goes away when the frame is grounded to the battery ground.
This cable provides a convenient way to groud the frame at bottle eyelets for systems that have the torque sensor attached to a Cycle Analyst and not the controller. Just plug one end into the unused 6-pin HiGo PAS plug of the motor controller, and the ring terminal on the other end gets screwed to the bike frame. An internal fuse protects against any shorts of other signals to the frame. This cable works with:
- Baserunners V4 onwards
- Phaserunner V6 onwards
- Frankenrunners
If you have a system where the torque sensor plugs into the motor controller directly, then use the appropriate WP8 Grounding Cable instead.
