V6 Phaserunner_MT Controller

The Phaserunner V6 MT model comes with an MT60 connector for three-phase power and JST plugs for hall sensors and temp/signal signals located right at the controller itself, and expects to use a separate motor cable harness to link this to the actual connector on your motor drive. We have stock motor adapter cables to Anderson, Z910, Spade, and L1019 terminations, and will be adding more. 

This controller will handle 90V Max and 90A of Peak Phase Currents (~45A Continuous) and comes in a Stainless Silver or Black Metal Shell

For connection to other ebike peripherals, it has

• 8 pin waterproof CA plug to mate with the CA3-WP device*
• 9 pin Mains connector that can be used for Superharness kits with 3rd party displays
• For standalone use, connect using the 9 Pin Mains to Throttle and Ebrake Breakout Cable
• 6 pin PAS connector for direct connection to various PAS devices

Power comes through an XT60M connector on the rear of the unit. Each Phaserunner comes with an Anderson terminated battery cable that connects into this XT60M on the rear.

Must be setup with via a computer to mate and configure with a given motor if they are not purchased together. This requires the USB->TTL communications cable if you don't already have one. Read more at the Full Phaserunner Information Page.

*Older CA3-DP or CA3-DPS will need the WP8->JST adapter for connection.